Filter
Top Products
32
Automatic Editing (deck-to-deck) (continued)
Checking the edit points
1 Press the IN (or OUT) button to check the edit point.
The value of the registered edit point appears on the
display.
2 While holding down the IN (or OUT) button, press the
PREROLL button to check the picture at the edit point.
The tape is cued up to the edit IN (or OUT) point, and a
still picture of the point appears.
z If “STOP” has been selected as the setup menu item
No.307 (AFTER CUE-UP) setting, the VTR is set to the
EE mode provided that EE has been selected as the
<HOME> menu (OUTPUT) setting.
3 By holding down the IN and OUT buttons at the same
time, check the editing duration. The duration appears
on the display.
How the duration is calculated
z When two edit points have been set
The duration between the two points is calculated.
z When only one edit point has been set
The duration between the data which has been set
and the current address is calculated.
z When no edit points have been set
The duration of the previously edited section is
calculated.
Modifying edit points
1 Re-registering an edit point
Locate the new edit point by performing the jog or shuttle
operation, and press the IN (or OUT) button and SET
button at the same time to re-register the edit point.
2 Modifying an edit point in 1-frame increments (trimming
function)
Press the TRIM button while holding down the IN (or
OUT) button.
Each time the i button is pressed, the point is moved
ahead by one frame.
Conversely, each time the j button is pressed, the point
is moved back by one frame.
3 Resetting edit points
1
Resetting both an edit IN point and OUT point
Press (TC CLR = RESET) on the <HOME>
menu.
(This takes effect only in the CTL mode.)
2
Resetting either an edit IN point or OUT point
Press the button among the number keys while
holding down the IN (or OUT) button.
<Notes>
z An edit OUT point can be reset even while editing is in
progress.
z In the eject mode, the IN and OUT points are
automatically reset.
F1
2 1, 3
F4
C
12
3
3