Filter
Top Products
47
Function menus (continued)
<HOME> (continued)
Registering TCG values
1 Selecting the values
Press the TC/CTL button to select TC.
Press the button. The selected item (cue time or TC)
is now highlighted.
Turn the ADJUST dial to select TC.
Again press the button. A single digit is highlighted,
and the mode for inputting numerical values is
established.
<Notes>
zThe UBG value and cue time can be registered in the
same way. The CTL value cannot be registered.
zTC or UB can be registered only when the internal time
code generator has been selected.
2 Inputting numbers and letters
Press the to number keys to input numerical
values.
Use the and buttons to input A, B and C, and the
and buttons to input D, E and F.
To move the input digit, turn the ADJUST dial.
To input a minus sign, press the and TRIM– buttons
when the left-most digit is highlighted.
To input a “plus” symbol, press and the TRIM+ button
or press when the digit to the far left is inverted. (The
display goes blank.)
To clear all the digits to zero, press the and
buttons.
<Notes>
z Every time when the button is pressed while
pressing the button, the display changes in the
following sequence: A
> B > C > A > B and so
on.
The same applies when D, E and F are input using
and .
z If, when “REV” has been selected as the setup menu
item No.144 (TC INPUT) setting, the button is
released while a letter is being input, the displayed
character will be entered.
z Letters can be input only while a UBG value is being
registered.
z The input of a minus number is possible only while
the cue time is being registered after “
d12h” is
selected as the setup menu No.002 (TAPE TIMER)
setting and CTL is selected by the TC/CTL
button.
z If “REV” has been selected as the setup menu item
No.144 (TC INPUT) setting, the input starts from the
highest order digit (the display appears from the far
right). However, turning the ADJUST dial once will
restore the NORMAL input mode.
3 Entering the input values
Press the button. The value input is registered,
and the normal display is restored.
<Notes>
z To cancel the registration, press the button.
z If the input value is outside the registration enable
range, the alarm blinks, and the value
cannot be registered until it has been corrected.
F3
T
T
0 9
F 7
F 8
F
F
0
F 0
7
F
F 8
F
F3
ENT
C
INVALID