Filter
Top Products
124
Rack mounting
The unit can be mounted into a 19-inch standard rack if the
optional rack-mounting adapters (AJ-MA75P : option) are
used. For the installation rails, it is recommended that the rail
and bracket for 18-inch length (part number C-300-S-118) of
Chassis Trak be used.
(The complete slide rail and bracket unit is not available from
Panasonic.)
For further details, consult your dealer.
1 Attach the inner members of the slide rails. Refer to the
figure below for the positions where they are screwed
into place.
<Notes>
z The length of the screws used is subject to a
restriction. Use screws which are less than 2/5 inch
(10 mm) long.
z Attach the inner member at the same symmetrical
positions on the left (L) side as well.
z
Fix the members in place using 3 screws on each
side (total: 6 screws).
z The letters shown in the figure are not actually marked
on the side panels.
2 Attach the outer member brackets to the rack. Check
that the height is the same for the left and right brackets.
3 Remove the four screws at the front used to attach the
left and right side panels.
4 Attach the AJ-MA75P rack-mounting adapters using the
same four screws.
5 Remove the four rubber feet on the bottom panel of the
VTR, and install the VTR in the rack.
After the VTR has been installed, check that it moves
smoothly along the rails.
<CAUTIONS>
z Keep the temperature inside the rack to between 5xC and
40xC (41xF and 104xF).
z Bolt the rack securely to the floor so that it will not topple
over when the VTR is pulled out.
ABCDEFGH
Positions where the right (R) inner member is screwed into place
Inner member
Rack-mounting adapters
EIAJ standard rack
Fasten to rack with the
fixing screws.