Filter
Top Products
57
● Pan/Tilt Control (Preset Operation)
The following function requires the use of cameras
equipped with the specific feature.
Note: Select only preset position numbers 1 to 16.
1. Select the desired monitor and camera referring to the
Camera Selection procedure described above.
2. Press the [PRE-POSI] button.
3. Select the preset position number by pressing the [1 –
16] button to move the pan/tilt head to the preset posi-
tion on the active monitor.
Note: Select a number from 1 through 16. (“17” is not
allowed.)
● Pan/Tilt Control (Home Position)
The following function requires the use of cameras
equipped with the specific feature.
1. Select the desired monitor and camera referring to the
Camera Selection procedure described above.
2. Press the [HOME/SET] button to move the camera to
the home position on the active monitor.
● Pan/Tilt Control (Auto Panning )
The following function requires the use of cameras
equipped with the specific feature.
1. Select the desired monitor and camera referring to the
Camera Selection procedure described above.
2. Press the [AUTO] button to activate the auto panning
function.
3. To cancel the auto panning function, press one of the
Direction buttons.
Note: When using the combination cameras with auto
panning feature, make sure that the LOCAL/
REMOTE setting is set to LOCAL at the camera site.
If REMOTE is selected, the panning movement is
retained for only one minute.
● Camera Setup
The following function requires the use of cameras
equipped with the specific feature.
1. Select the desired monitor and camera referring to the
Camera Selection procedure described above.
2. Press the [SET UP/ESC] button, while holding down the
selected [CAMERA] button, to gain access to the cam-
era setup menu on the active monitor.
3. Select the desired item by pressing the D or C button,
and then select the desired mode by pressing the A or
B button.
4. Press the [HOME/SET] button to execute the setting or
enter a submenu.
5. Press the A and B buttons simultaneously to reset the
selected menu.
6. Press the [SET UP/ESC] button to execute the setting
and returns to the previous setup menu.
PRE-POSI
AUTO
** CAM SET UP **
CAMERA ID OFF
ALC/ELC ALC
SHUTTER ---
AGC ON
SENS UP OFF
SYNC INT
WHITE BAL AWC
MOTION DET ON
LENS DRIVE DC
END SET UP DISABLE
↵↵↵↵
SET UP/ESC
4
8
12
16
3
7
11
15
2
6
10
14
1
5
9
13
CAMERA/PRESET POSITION
LEFT
RIGHT
UP
DOWN
HOME/SET
LEFT
RIGHT
UP
DOWN
HOME/SET