Panasonic WJ-FS616C Home Theater Server User Manual


 
63
Recording on the Time Lapse VCR
The following selections are made in the WJ-FS616C
SETUP MENU described previously.
Refer to the Recording Mode Setup on page 33 for further
details.
1. Check the selected recording mode (MODE 0 - MODE
9).
MODE 0: Normal Mode (Real Time)
MODE 1 - 9: Time Lapse Mode (Linear Mode)
If MODE 9 is selected, check the image (spot or
quad) to be recorded on the VCR.
2. Press the Record button of the VCR to begin recording.
Notes:
To let the VCR display the VCR menu for setup,
select MODE 0 in the REC MODE SETUP menu of
the multiplexer.
While recording with the camera switching pulse
(MODE 9), quad recording will work properly when
the selected recording interval is more than 0.11
seconds (less than 9 fields/s).
While recording without the camera switching pulse
(MODE 1 – 8), quad recording is not available.
When using a VCR whose recording interval is 2 or
3 fields, select 4 fields (minimum) for the REC
MODE parameter.
However the same image may be recorded repeat-
edly.
Camera Switching Pulse Loss
Display
When loss of the camera switching pulse is detected,
“SW LOSS” will blink on the monitor screen.
The buzzer does not beep.
When the camera switching pulse is recovered, “SW
LOSS” is cleared from the monitor.
Notes:
When MODE 0 to MODE 8 is selected for recording,
or MULTI2 OUTPUT for REC/ MULTI2, “SW LOSS”
is not displayed because of the way the system
application works.
If “ALARM” or “CH✽✽LOSS” is displayed on the
monitor screen, “SW LOSS” is not displayed
because alarm has priority.
OTHER FUNCTION