Filter
Top Products
58
7. Press the [SET UP/ESC] button, while holding the
[FUNCTION] button, to exit from the setup mode or
menu.
Note: Refer to the operating instructions of the selected
camera for further details.
Caution: Camera addresses are important for RS-485
type cameras.
• Do not use addresses other than 1 through 16
for individual cameras. (“17” is not allowed)
• Do not set a single address for more than one
camera in an RS-485 chain.
• Simplified preset position setting
The preset position can be set by a simplified proce-
dure.
The following function requires the use of cameras
equipped with the specific feature.
1. Press the [FUNCTION] button while the position set-
ting menu is displayed on the active monitor.
2. Press the Direction buttons to move the pan/tilt
head in the desired direction.
3. Press the [FOCUS] or [ZOOM] button to adjust the
lens to achieve the desired image.
4. Press the [FUNCTION] button again to restore the
Direction buttons’ cursor control function.
SET UP/ESC
FUNCTION