Filter
Top Products
10 English
INTRODUCTION
3 INSTALLATION AND CONNECTIONS
This section describes how to connect the digital video recorder to video cameras and other devices. Be sure to read the
instruction manuals for each connected device.
z Improper connections can result in malfunction or the
emission of smoke.
z A separate power supply is required for operation of
each camera.
The following diagram shows the connections for cameras, monitors, a microphone, and a PC.
An amplifier is connected when using a microphone or
external speakers with the digital video recorder.
When using external alarms (i.e., intruder sensors and the
like), external switches are to be connected to the ALARM
IN terminals.
Basic connections
AC IN
MON2MAIN
MONITOR
MIC IN
OUTIN
AUDIO
123456
IN
OUT
VIDEO
LAN
RS485
DO NOT CONNECT TO PHONE LINE
BA
ALARM IN
SENSOR
ALARM OUT
ALARM OUT
C123456CC
CCCR1R2
C123456C
ALL
RESET
RS485
TERMINATE
ON
OFF
REMOTE
ALARM
FULL
ALARM
RISET
CL
OCK
S
ET
IN
CL
OCK
S
E
T
IN
NON RE
C
OUT
WA
RNING
OUT
F
U
LL
E
X
I
T
T
I
ME
R IN
0201
04
03
* Wrap the microphone
cable twice around the
supplied core clamp
before attaching it.
Video input
terminal
PC
Monitor
(sold separately)
Video input
terminal
Monitor
(sold separately)
120V-240V AC
(50/60 Hz)
* If the monitor 2 (MON2) is not synchronized
with the connected cameras, vertical picture
instability may occur upon the switching of
camera video.
Camera
(sold separately)
Microphone
*
System contoroller
Connecting an amplifier
IN
OUT
Audio input
Audio
output
Amp
(sold separately)
Connecting ALARM IN terminals
C123 6C45
Connecting ALARM IN
terminals to external
switches
e00_l8hbe_xe_7.book Page 10 Tuesday, April 27, 2004 10:35 AM