Filter
Top Products
RECORD SET3
English 61
2 Turn the jog dial to select setting (OFF,
for example), and then turn the shuttle
dial clockwise.
“REMAINING DISK WARNING” changes to “1%” from “**”.
[Settings] ( indicates the default setting)
.
z If this is set to “OFF”, the FULL indicator or ALARM
FULL indicator will start to flash when the remaining
hard-disk capacity reaches the percentage set for
“REMAINING DISK WARNING”.
3 Use the same procedure to set “ALARM
RECORDING AREA” to “OFF”.
4 Turn the jog dial to select “REMAINING
DISK WARNING”, and then turn the
shuttle dial clockwise.
5 Turn the jog dial to set a “REMAINING
DISK WARNING”, and then turn the
shuttle dial clockwise.
The remaining capacity can be set anywhere between 1%
(default) and 10%.
6 Press the [EXIT] button.
The setting procedure is ended and the display returns to
the normal screen.
A warning will be displayed in the operation display area
when the remaining capacity for any recording area reaches
the specified percentage value. In addition, the FULL
indicator (for the normal recording area) or the ALARM FULL
indicator (for the alarm recording area) will flash at this time.
You can set a storage period for recorded data as
described below. When the set period has expired, the
corresponding data will be automatically deleted.
1
Turn the jog dial to select “AUTO DELETE”,
and then turn the shuttle dial clockwise.
“OFF” flashes.
2 Turn the jog dial to select the storage
period.
You can set the storage period for recorded data “OFF“ or
within a range of “1 DAY” - “99 DAYS” (full days).
Setting Description
OFF
Recording is stopped when the normal recording area
becomes full.
ON
Overwriting automatically starts from the beginning of
the normal recording area when it becomes full.
Remaining disk
warning
Setting auto deleting
EXIT
01-01-04 00:00:00 REC 1% EN A ALARM 0000
02
FULL indicator ALARM FULL indicator
Remaining
capacity
display
Operation
display area
e00_l8hbe_xe_7.book Page 61 Tuesday, April 27, 2004 10:35 AM