Filter
Top Products
INITIAL SET2
52 English
SETTINGS
8 Turn the jog dial to set T2 (minutes) to
“30” (minutes), and then turn the shuttle
dial clockwise.
“00:” from T3 flashes (indicating the hour).
Repeat steps 4 through 7 to make hour and minute
settings for T3 and T4.
9 In the same manner as described set
the hours and minutes of T1, T2, T3, and
T4 for “TIME PERIOD B” settings.
For both TIME PERIOD A and TIME PERIOD B, all
settings are “00:00” by default.
z Settings for T1 through T4 cannot be made in such a
way that they extend over two days (i.e., include
midnight). If “00:00” (midnight) must be set, this should
be done using T1.
Any setting of “00:00” for T2 through T4 will be skipped.
Example: T1 T2 T3 T4
06:00 12:00 18:00 00:00
In the above example, T4 (00:00) is skipped and T3
operates between 18:00 and 06:00.
z Furthermore, when T1 through T4 are all set to “00:00”,
all but T1 are ignored, and T1 operates from midnight to
midnight.
Example 2: Setting time period operation as follows.
Automatic selection and monitor masking for TIME
PERIOD A.
Motion sensing for TIME PERIOD B.
1 Turn the jog dial to move the cursor to
“SEQUENCE” within “SELECT TIME
PERIOD”, and then turn the shuttle dial
clockwise.
“TIME PERIOD A” flashes.
2 Turn the jog dial to select “TIME
PERIOD A” or “TIME PERIOD B”, and
then turn the shuttle dial clockwise.
The cursor moves to “MASK”.
3 Set the time period for “MASK” and
“MOTION SENSOR” in the same way.
4 Press the [EXIT] button.
The setting procedure is ended and the display returns to
the normal screen.
Automatic selection, masking, and motion sensors are all
set to “TIME PERIOD A” by default.
z As a result of the above operations, “SEQUENCE” are
updated using main monitor and monitor 2 settings on
P.90; “MASK” are updated using mask settings from on
P.92; and “MOTION SENSOR” are updated using
motion sensor settings on
P.72.
Time period operations settings
EXIT
e00_l8hbe_xe_7.book Page 52 Tuesday, April 27, 2004 10:35 AM