Filter
Top Products
RECORD SET3
English 63
z Audio recording can only be specified when “REC
RATE” is between A 60.00 and A 1.00 FPS.
z When set to “ON”, the letter “A (indicating that audio will
be recorded)” is displayed in front of the recording rate.
As both video and audio will be stored in the normal
recording area, this area’s overall capacity will reduce
accordingly.
z Audio will only be output during playback at the same
rate as recording.
z Audio and video may be slightly out of synchrony in
certain situations.
7 Set “REC RATE”.
(Default setting: 15.00 FPS)
(Example: 6.00)
Allowable recording time is dependent on the setting made
for “PICTURE QUALITY”. For more details, see the “Table
of recording rate and times” (JP.103).
z When pre-alarm recording is set to “ON”, the recording
rate is limited to 30.00 FPS (and a setting of 60.00 FPS
cannot be made).
8 Set “REC PROGRAM GROUP”.
See (JP.63) for more details regarding program
recording.
(Example: P-1)
[Settings] ( indicates the default setting)
9 Press the [EXIT] button.
The setting procedure is ended and the display returns to
the normal screen.
Use the following procedure to record from specified
cameras. A total of four programs (No. 1 through No. 4)
can be setup for this purpose. For example, Program No. 1
could be setup to record from cameras No. 1 through No. 4
only, whereas Program No. 2 could be setup to record
from cameras No. 3 through No. 6. In addition, these
programs can also be used for timer recording.
z Even if audio recording is set to “ON” using the
<NORMAL REC MODE SET> screen, certain settings
for program recording may make it impossible for audio
to be recorded. When audio is to be recorded, you are
recommended to do a trial recording first of all to
confirm that this is possible.
Example:
Setting Program No. 1 to record video from cameras No. 1
through No. 3
(1) PROGRAM
Selects Program No. 1 through Program No. 4.
(2) SELECT INDIVIDUAL CAMERA RATE
Sets which of the connected cameras (1 through 6) to
record from. Recording rates can also be set for each
camera.
1 Press the [MENU] button, turn the jog
dial to select “2. RECORD SET”, and
then turn the shuttle dial clockwise.
The <RECORD SET> screen is displayed.
Setting Description
OFF Video from all cameras is recording at the same rate.
P-1 Used when recording with Program No. 1.
P-2 Used when recording with Program No. 2.
P-3 Used when recording with Program No. 3.
P-4 Used when recording with Program No. 4.
Allowable recording
time
EXIT
Setting program recording
(1)
(2)
MENU
e00_l8hbe_xe_7.book Page 63 Tuesday, April 27, 2004 10:35 AM