Filter
Top Products
RECORD SET3
72 English
SETTINGS
Use the following procedure to set motion sensor on video
from each camera so that alarms can be detected.
(1) Motion sensor setting
Displays changes in response to the sensor condition,
and settings are made turning the jog dial.
-: Sensor off
A or B: Sensor on
(2) Camera number display
Changes when a [CAMERA SELECT] button is
pressed. Use this item to select the camera for which
motion sensors are to be setup.
(3) Time period
Select an interval as set using “TIME PERIOD” on
P.50.
(4) LEVEL
Sets the sensitivity level of the motion sensors.
OFF: No motion sensor has been set.
1 to 10: A motion sensor is set. Lower values
correspond to higher sensitivity levels and vice versa.
(5) MODE
Sets the detection method for the motion sensors.
(JP.72)
z Refer to “NAMES AND FUNCTIONS OF PARTS” for
more details regarding operation of the jog dial and
shuttle dial. (JP.8)
1 Make timer settings for “TIME PERIOD
A” and “TIME PERIOD B” from <TIME
PERIOD SET>. (JP.50)
2 Turn the jog dial select “MOTION
SENSOR”, and then turn the shuttle dial
clockwise.
The motion sensor screen is displayed.
3 Press the [CAMERA SELECT] button.
Select the camera for which motion sensors are to be
setup.
4 Turn the jog dial clockwise or counter-
clockwise to move the cursor (blue) to
the position where a sensor is to be set.
5 Turn the shuttle dial clockwise, and
then turn the jog dial to select “A” or
“B”.
“A” or “B”: Sensor set
“-” : No sensor
6 Turn the shuttle dial clockwise.
After confirming this setting, the cursor (blue) moves one
position to the right.
7 Use this procedure to set other sensor
positions.
Setting the motion sensors
(1)
(2)
(3)
(4) (5)
Motion sensor
screen
The cursor (blue) is
displayed at the top left
position.
e00_l8hbe_xe_7.book Page 72 Tuesday, April 27, 2004 10:35 AM