Filter
Top Products
RECORDING3
English 21
Use the following procedure to record video from
immediately before occurrence of an alarm.
1 Set pre-alarm recording.
Follow the instructions on
P.68
set “7. ALARM REC MODE
SET” from <RECORD SET> to “PRE-ALARM
RECORDING”.
2 After entering the setting, press the
[EXIT] button.
The setting procedure is ended and the display returns to
the normal screen.
“PRE” appears in the operation display area. Pre-alarm
recording starts (without the “REC” symbol being
displayed).
Pre-alarm recording is automatically ended and alarm
recording starts.
z “PRE” from the operation display area is replaced by
“ALARM”, and “ALARM” starts to flash.
z When recording for the first time, the default settings
are used. For details regarding modification of the
picture quality or recording rate, see P.62.
z When the space remaining in the alarm recording area
drops below a preset value, the FULL indicator on the
digital video recorder’s front panel starts to flash. If
recording is continued beyond this point, the alarm
recording area will become full, recording will stop, and
the FULL indicator will stop flashing and remain lit. In
such a case, use the <RECORDING AREA SET> menu
to perform “AREA FULL RESET” for the alarm
recording area, thus allowing recording to start again
from the beginning. (JP.60)
Pre-alarm recording
02
01-01-04 00:00:00 EN A PRE 0000
EXIT
If an alarm is detected
01-01-04 00:00:00 REC REPEAT EN A ALARM 0000
02
ALARM FULL indicator
e00_l8hbe_xe_7.book Page 21 Tuesday, April 27, 2004 10:35 AM