Filter
Top Products
GENERAL SET4
82 English
SETTINGS
3 Turn the shuttle dial clockwise.
<WARNING> screen is displayed. “NO” flashes.
4 Turn the jog dial to select “YES”.
5 Turn the shuttle dial clockwise.
The “HDD INITIALIZING!” screen is displayed, and the
hard disk is initialized.
When initialization has been completed, the display
returns to the <HDD SET> screen.
6 Press the [EXIT] button.
The setting procedure is ended and the display returns to
the normal screen.
Please contact your local store or service center regarding
hard disk expansion. A special expansion kit will be
required in order to perform this procedure.
[Setting conditions]
z Initialization must always be carried out after hard disk
expansion.
The <HDD SET> screen
z MIRRORING: When hard disk expansion has been
carried out, the same video can be recorded to both
hard disks. Accordingly, if a problem occurs with
recording to one of the hard disks, the <HDD SET>
screen can be used to select the other hard disk for
provision of readable data. When mirroring has been
set, the recording rate is controlled automatically (i.e.,
set to half of the normal value) and the appropriate care
must be taken.
z PLAYBACK DRIVE: This parameter is used together
with “MIRRORING” and it indicates which of the two
hard disks is to be used to provide recordings for
playback.
z If a playback problem occurs while mirroring is turned
on, change the hard disk used for playback.
z If hard disk expansion has been carried out,
initialization is performed for both hard disks
simultaneously, and all data will be lost.
z All important recordings should be copied to
CompactFlash cards or another storage medium before
hard disk expansion.
Use the following procedure to make digital video recorder
menu settings and to monitor video from a PC via a
network (LAN).
A LAN cable must be connected to the LAN terminal on
the rear panel before proceeding.
z Connecting to a PC directly
(without using a hub)
Expanding the hard disk capacity
EXIT
Network settings
Making network connections
2
1
3
4
Main Monitor
Monitor
(sold separately)
A cross-type LAN cable must
be used here.
(10 BASE-T/100 BASE-TX
Category 5)
PC
e00_l8hbe_xe_7.book Page 82 Tuesday, April 27, 2004 10:35 AM