Filter
Top Products
2-66
Section 2 — Installation
JSO Cable connection
The JSO cable is an optional cable that is installed if you want to use the
joystick override function of the Remote Aux Panel. The JSO cable is not
supplied by GVP. Refer to Figure 2-33.
Figure 2-33. JSO Cable Connection
Power Supply Installation
The Remote Aux Panel Power Supply should be securely fastened either on
a horizontal surface where it will not be disturbed, or attached to a support
inside the equipment rack. Verify that the power supply cord will reach the
Remote Aux Control Panel and the AC source. The power supply requires
100–120 VAC or 200–240 VAC and automatically switches to select one of
these two line voltages.
1
2
3
4
5
6
7
8
9
1
2
3
4
5
6
7
8
Male 9 PIn
D Connector
Momentary
Pushbuttonsr
The Joy Stick Override Cable is customer supplied.
The cable is connected to a male 9 pin D connector
which has 4-40 jack screws. For EMI supression,
the cable shield should be connected to the metal
connector cover.
Figure 2-34. Remote Aux Panel Power Supply