Filter
Top Products
Installing the SDI Card, cont’d
MGP 462 • Installing the SDI cardB-4
7. The SDI input card has a 20-pin socket on the underside which must align
with the 20 pins on the main circuit board. Be sure to align the pins properly
to prevent bending them, before pressing the SDI card down firmly in place
onto the standoff. The mounting hole on the SDI card should now be directly
over the standoff. See the following picture.
Aligning the 20-pin connector with its socket under the board
8. Insert the SDI card’s installation screw through the card’s mounting hole and
gently tighten it into the standoff. See the picture below.
Installed SDI input card
20-pin Socket
Connector Pins
Installation Screw
Hol
e
Standoff