Filter
Top Products
4-27MGP 462 • Software Configuration and Control
Command/response table for IP control port commands (continued)
Command ASCII (Telnet) URL Encoded (Web) Response Additional description
(host to processor) (host to processor) (processor to host)
IP setup commands, continued
Clear user password
24
Esc
• CU W%20CU
|
Ipu • This clears the user password only.
Read user password
24
Esc
CU WCU
|
X33
Set Verbose mode
24
Esc
X22
CV W
X22
CV
|
X22
Enable or disable the Verbose
mode. For
X22
:
0 = off (disabled)
1 = on (enabled)
2 = tagged responses for queries
3 = verbose mode and tagged
responses for queries
The MGP can send out unsolicited information (such as notice of a volume or input change or a change in some other setting). That is called verbose (wordy) relationship
between the processor and a connected device. For a direct RS-232/422 connection, the processor is set for Verbose mode by default. When the MGP 462 is
connected via Ethernet, Verbose mode is disabled by default in order to reduce the amount of communication traffic on the network. If you want to use the Verbose
mode with a processor connected via Ethernet, this mode must be set to On each time you reconnect to the processor.
Read Verbose mode
Esc
CV WCV
|
X22
Read connection’s security level
Esc
CK WCK
|
X52
For
X52
:
0 = anonymous
1–10 = extended security levels
1 through 10
11 = User
12 = Administrator
With tagged response – verbose modes 2 and 3:
Pvl
X52
Remapping port designations
Set Telnet port map
24
Esc
{port#}MT W{port#}MT
|
Pmt {port#}
Reset Telnet port map
24
Esc
23MT W23MT
|
Pmt 00023
Disable Telnet port map
24
Esc
0MT W0MT
|
Pmt 00000
Read Telnet port map
Esc
MT WMT
|
{port#}
Set Web port map
24
Esc
{port#}MH W{port#}MH
|
Pmh {port#}
Reset Web port map
24
Esc
80MH W80MH
|
Pmh 00080
Disable Web port map
24
Esc
0MH W0MH
|
Pmh 00000
Read Web port map
24
Esc
MH WMH
|
{port#}
Set Direct Access port map
24
Esc
{port#}MD W{port#}MD
|
Pmd {port#}