Filter
Top Products
2-7MGP 462 • Installation
Remote control connector
7
RS-232/422 connector — Plug a computer or other
RS-232 or RS-422 host device into this female D-sub
connector. Wire the connector as shown in the tables
below. For more information on controlling the
MGP 462 remotely, see chapter 4, Software Configuration
and Control.
Pin assignments for the RS-232/422 connector
Output connectors
8
Output connectors — Plug one or two output devices into the 5-BNC and/or
the 15-pin HD connector. (When two output devices are attached, they both
display the same picture.)
R
/R-Y
G
/Y
B
/B-Y
HVS
R
/R-Y
G
/Y
B
/B-Y
HVS
R
/R-Y
G
/Y
B
/B-Y
HVS
R
/R-Y
G
/Y
B
/B-Y
HVS
RGBHV RGBS
RGsB HDTV Component Video
BNC output connectors
Power connector
9
AC power connector — Plug the power cord provided with the MGP 462 into
this connector to connect the MGP 462 to a 100–250 VAC, 50/60 Hz power
source.
51
96
Pin RS-232 function Description
1 – No connection
2 Tx Transmit data
3 Rx Receive data
4 – No connection
5 Gnd Signal ground
6 – No connection
7 – No connection
8 – No connection
9 – No connection
Pin RS-422 function Description
1 – No connection
2 Tx- Transmit ground
3 Rx- Receive ground
4 – No connection
5 Gnd Signal ground
6 – No connection
7 Rx+ Receive data
8 Tx+ Transmit data
9 – No connection