Filter
Top Products
Software Configuration and Control, cont’d
MGP 462 • Software Configuration and Control4-26
Command/response table for IP control port commands (continued)
Command ASCII (Telnet) URL Encoded (Web) Response Additional description
(host to processor) (host to processor) (processor to host)
IP setup commands, continued
Read IP address
24
Esc
CI WCI
|
X14
Leading zeros in each of the four
fields are suppressed in returned.
values.
Read hardware address (MAC)
Esc
CH WCH
|
X
18
X
18
= hardware media access
control (MAC) address
(xx-xx-xx-xx-xx-xx).
Set subnet mask
24
Esc
X19
CS W
X19
CS
|
Ips •
X19
X19
= subnet mask
(xxx.xxx.xxx.xxx). Syntax is the
same as for IP addresses. Leading
zeros are optional in setting
values.
Read subnet mask
Esc
CS WCS
|
X19
Leading zeros are suppressed.
Set gateway IP address
24
Esc
X14
CG W
X14
CG
|
Ipg •
X14
X14
= IP address
(xxx.xxx.xxx.xxx).
Leading zeros are optional.
Read gateway IP address
Esc
CG WCG
|
X14
Set administrator password
24
Esc
X33
CA W
X33
CA
|
Ipa •
X33
Set the administrator access
password. (
X33
is 4-12
alphanumeric characters.) The
password is case sensitive.
Special characters (spaces or
symbols) are not allowed.
Clear administrator password
24
Esc
• CA W%20CA
|
Ipa • Clear/remove all passwords
(administrator and user).
A user password cannot be assigned if an administrator password does not exist. Entering a password when the MGP462 has not been configure yields an E14
response from the processor. If the administrator password is cleared (removed), the user password is also removed.
Read administrator password
Esc
CA WCA
|
X33
Set user password
14
24
Esc
X33
CU W
X33
CU
|
Ipu •
X33
Set the user password.
(
X33
is 4-12 alphanumeric
characters.) The password is
case sensitive. Special
characters (spaces or symbols)are
not allowed.
A user password cannot be assigned if an administrator password does not exist.