Filter
Top Products
5 Virtual-IO Manager user interface
linkdown event is then triggered if all ports configured as active and all
ports configured as backup ports of an uplink set fail. This allows the
LAN connection to remain intact.
In order for the failover process in the server blade to work from LAN port
1 to LAN port 2, a LAN team must have been configured on the server
blade and the network on the second IBP module must have been con-
figured accordingly.
Enable LACP
You activate the LACP protocol via Enable LACP.
Isolate mode
You activate the isolate mode via Isolate mode. With isolate mode acti-
vated, server blades in the same chassis that use the same network can-
not communicate with each other, but only with an external device
though the uplinks.
This checkbox is not shown if the connection blade does not support iso-
late mode or if VLAN networks are edited.
Link Speed
By selecting a Link Speed, you can select the transmission speed. If
auto negotiation is not selected on the external switch, configure this
value if a problem occurs using the drop-down menu according to the set-
tings on the external switch. The following values are available:
Auto negotiation
The transmission speed is negotiated with the external switch. You
can achieve a transmission speed of 1 Gbit/s with this value.
10 Mbit/s
10 Mbit/s full-duplex.
100 Mbit/s
100 Mbit/s full-duplex.
178 ServerView Virtual-IO Manager