Filter
Top Products
Figure 55: CNA Parameter step
Enable DCB Settings
This option is available only for FCoE and iSCSI functions. It enables
the DCB (Data Center Bridging) feature of the connection blade. The
DCB settings here are specific configuration settings in a DCB-enabled
switching device.
This option should be enabled if the profile will be used in a blade server
chassis where the corresponding physical CNA port will be connected to
a PY CB Eth Switch/IBP 10 Gb 18/8 (SBAX2) connection blade in IBP
mode.
If the port of the server blade, where the profile will be used, is connected
to a LAN pass-thru module or a PY CB Eth Switch/IBP 10 Gb 18/8
(SBAX2) connection blade in switch mode, the option Enable DCB set-
tings should not be set.
Priority Level
The priority level. Possible values are 0 to 7; for FCoE this is by default
the value 3, for iSCSI the default value is 4.
ServerView Virtual-IO Manager 219
5.4 Wizards