Filter
Top Products
5 Virtual-IO Manager user interface
value if a problem occurs using the drop-down menu according to the set-
tings on the external switch. The following values are available:
Auto negotiation
The transmission speed is negotiated with the external switch. You
can achieve a transmission speed of 1 Gbit/s with this value.
10 Mbit/s
10 Mbit/s full-duplex.
100 Mbit/s
100 Mbit/s full-duplex.
Service VLAN id
A Service VLAN ID must be specified.
IGMP Snooping
If IGMP Snooping is activated, the connection blade controls whether
requests to join a multicast group occur at the downlink ports of an uplink
set. If necessary, the corresponding downlink ports may be added to the
forwarding table of this multicast group or removed again.
Ports for the uplink set (change with right click)
Assign the required ports of the IBP to the uplink set. To do this, open
the context menu of each relevant port. If an uplink set for a switch stack
is defined, the uplink ports of all IBPs belonging to the stack are shown
one below the other. Use the scroll bar to reach the uplink ports of
another stack member.
The context menu can contain the following menu items:
Add
Only activated if the port is not yet assigned to the uplink set.
Assigns the port to the uplink set. If the port is already assigned to
another uplink set, this assignment is deleted.
Add as Backup
Only activated if the port is not yet assigned to the uplink set.
182 ServerView Virtual-IO Manager