Filter
Top Products
Installation
Document 900.0856 Rev 3.00 29
11/07
Caution Do NOT connect or disconnect SCSI devices while the DVR
power is on. The DVR must be powered down to connect or
disconnect SCSI devices. Power up SCSI devices so they are
ready for operation before powering up the DVR. Power down
SCSI devices after powering down the DVR and then disconnect
SCSI devices.
Caution If the SCSI device is shut down while the device is operating, the
DVR system might not operate normally.
Connecting to the Network Port
Figure 2-15 Network Connector
The DVR can be networked using the 10/100Mb Ethernet connector. Connect a Cat5
cable with an RJ-45 jack to the DVR connector. The DVR can be networked with a
computer for remote monitoring, searching, configuration and software upgrades. See
Chapter 3, Configuration for configuring the Ethernet connections.
Caution The network connecter is not designed to be connected with
cable or wire intended for outdoor use.