Filter
Top Products
Configuration
40
2. Highlight the Site box and press . A virtual keyboard appears that you can use
to enter a Site Name.
3. Once you have entered your title, highlight OK and press .
4. Highlight the box beside System ID and press . Change the number by
highlighting it and using the Up and Down arrow buttons to increase and
decrease the number from 0 to 99.
Note The System ID number is used to identify the unit when it is
connected with other DVRs through the RS485 port. You cannot
use the same ID number for two or more DVRs that are in the
same RS485 network. It is possible to have multiple DVRs with
System ID 0 that are in the same area as long as they are not
part of an RS485 network. If this is the case, all will be controlled
at the same time when using the infrared remote control.
5. Highlight the box beside Language and press . A drop-down menu displays
the available languages. Highlight the desired language and press .
6. The box beside Version displays the software version of the DVR. To upgrade the
software:
a. Connect a USB device containing the upgrade package file to the DVR.
b. Highlight Upgrade… and press . The Upgrade screen appears. The
screen displays the upgrade package file names that are available. The .rui
indicates that the file is for software upgrades.
c. Select the desired file and press .
d. Highlighting Install and pressing will install the selected software
package. Highlighting Cancel and pressing will close the window without
upgrading the software.
If the upgrade package file is not installed on the DVR properly, you will get
an error message.
e. The system restarts automatically after completing the upgrade.
Figure 3-7 Upgrade Screen
Note Upgrade will be deactivated if the hard disk drive has not been
formatted as it requires the space for temporary files when
upgrading the system.