Filter
Top Products
Configuration
Document 900.0856 Rev 3.00 93
11/07
Note Mail notify is the only option available for the System event.
Note For the Notify action to work, the DVR should be registered in the
RAS (Remote Administration System).
17. You can save your System Event changes by highlighting Save and pressing .
Selecting Cancel exits the screen without saving the changes.
Event Status Screen
Highlight Event Status in the Event menu and press . The Event Status screen
(Figure 3-80) appears.
Figure 3-80 Event Status Screen
The Event Status screen displays the status of the DVR’s systems and inputs. The
following events will be highlighted, and related channels or events will flicker for five
seconds when detected:
• Alarm-In, Motion, Video Loss and Text-In will be highlighted when each event is
detected based on the settings you made in the Alarm-In, Motion Detection, Video
Loss and Text-In setup screens on the Event menu.
• Check Alarm-In and Check Recording will be highlighted when each event is
detected based on the settings you made in the System Event setup screen on
the Event menu.
• Panic Record will be highlighted while the DVR is in the panic recording mode.