Filter
Top Products
Configuration
82
Note For the Alarm-Out action, the alarm output and beep you select
should be set to the Event mode in the Alarm-Out setup screen,
Schedule tab (see Alarm-Out Screen, page 65).
14. Highlight the box under the Notify heading and press . You can toggle the
entire list On and Off by highlighting Notification and pressing . You can
toggle the individual items On and Off by highlighting that item and pressing .
Highlight OK and press to accept your changes.
Note For the Notify action, the notify item you select should be
enabled in the Notification setup screen and the DVR should be
registered in the RAS (Remote Administration System).
Figure 3-66 Motion Detection Actions 2 Screen
15. In the Actions 2 tab, highlight the desired box under the PTZ heading, and press
. A list of PTZ presets appears. Select the preset position for each PTZ camera,
where you want PTZ cameras to move to whenever the DVR detects motion on
the selected camera’s input.
16. Highlight the desired box under the Spot Monitor heading, and press . A list of
SPOT monitors and cameras appears. Each SPOT monitor can be associated
with a camera. The DVR will display the associated camera on the SPOT monitor
whenever it detects motion on the selected camera.
17. You can save your Motion Detection changes by highlighting Save and pressing
. Selecting Cancel exits the screen without saving the changes.