Filter
Top Products
Configuration
Document 900.0856 Rev 3.00 53
11/07
Figure 3-25 LAN (Manual) Setup Screen
2. Highlight the box beside Type and press . You can select the type of network
configuration from: Manual, DHCP and ADSL (with PPPoE). Select the desired
type and press .
3. Selecting Manual as the Type allows you to set up LAN parameters manually.
Note You will need to get the appropriate IP Address, Gateway and
Subnet Mask values from your network administrator.
a. Change the numbers by highlighting them and using the Up and Down arrow
buttons to increase or decrease the number.
The factory default LAN settings are:
IP Address: 192.168.1.129
Gateway: 192.168.1.254
Subnet Mask: 255.255.255.0
b. Highlight the box beside DNS Server. Press the Up and Down arrow buttons
to set the IP address of the DNS server.
c. Highlight the Port Number Setup… box and press . The Port Number
Setup screen (Figure 3-26) appears.
Note You will need to get the appropriate Port Numbers for each RAS
and WebGuard related program (Admin, Callback, Watch and
Search) from your network administrator.