Intel A31032-001 TV Mount User Manual


 
C H A P T E R 6 Remote Telnet Sessions
6-5
Remote Console, Telnet
With remote Telnet enabled on the 7110/7115, use the following
procedure to access it’s CLI:
Unix-prompt> telnet 10.1.1.1
Trying 10.1.1.1...
Connected to 10.1.1.1.
Escape character is ’^]’.
.
.
.
Serial 0:a0:a5:11:4:2e
password:<password>
NOTE: If other remote
sessions are already
running and the new one
exceeds the number
allowed as configured
with the set
max_remote_sessions
command, the CLI
displays the message,
“Max Remote Sesion
Limit of (5) exceeded!”
Either close a session, or
increase the maximum
number allowed.
After you enter your password, the Telnet session displays the 7110/
7115’s CLI. From this point, you can manage the device as you would
from the local serial console, minus the few disallowed commands
listed in the “Limitations” section near the beginning of this chapter.
Changing the Telnet Port
The Telnet port is set and displayed by using the CLI commands, set
telnet_port <port
> and show telnet_port.
These commands are available only at the local serial console and
when the remote management is enabled. By default, the Telnet port
number is 23.
To set the Telnet port:
Intel 7115> set telnet_port 230
To display the Telnet port:
Intel 7115> show telnet_port
Telnet Port Number: 23
0