Filter
Top Products
C H A P T E R 5 Intel® NetStructure™ 7110/7115 e-Commerce Accelerator User Guide
5-28
set telnet Enables or disables Telnet sessions. When this command is set to
“enable” and an IP address is assigned to the 7115’s network
interface, you can access the device’s CLI via remote Telnet
session. When disabled, the device refuses Telnet connections. The
console prompts for any missing parameters. Default: disable.
Syntax:
Intel 7115> set telnet enable
Need an IP address to start Telnet service.
Enter IP Address [209.218.240.67]:
10.1.2.124
Need a netmask to start Telnet service.
Enter Netmask [255.255.255.0]:
Optional Default Route to start Telnet
service.
Enter Default Route (’none’ to delete)
[none]:
Telnet Services started.
Intel 7115>
show telnet Displays current telnet status: enabled or disabled.
Example:
Intel 7115> show telnet
Telnet: Enabled
set telnet_port Set the port on which Telnet connections are accepted. (Default
port: 23.)
Syntax:
Intel 7115> set telnet_port <port>
where <port> is the number of the port to which Telnet sessions
will connect.
Command Description