Filter
Top Products
C H A P T E R 4 Scenario 3—Multiple 7110/7115s, Cascaded
4-7
8. Save the configuration when mapping is completed for the
server(s).
Intel 7115>config save
Saving configuration to flash...
Configuration saved to flash
Intel 7115>
Scenario 3—Multiple 7110/
7115s, Cascaded
This scenario shows how to cascade 7110/7115s for additional
performance and availability. The same procedures apply that were
performed in Scenario 3. In addition, the complete configuration of
the first 7110/7115 is exported to the second 7110/7115 in line.
Assumptions
• Two or more 7110/7115s must be physically installed on the
same network. To cascade multiple 7110/7115s, connect from the
server port of the first 7110/7115 to the network port of the next
7110/7115 in line, and then again connect from the server port to
the network port of the next 7110/7115 in line, or to the server.
(See Chapter 2: Installation for more information.)
• On the first 7110/7115, the set spill enable command is used to
enable spilling so that the next 7110/7115 in line can handle the
overflow. Spill is then enabled for each subsequent 7110/7115,
except the last one. Do not configure the last 7110/7115 to spill
to the server.
• The first 7110/7115 should be fully configured; any necessary
keys, certificates or maps must exist. The complete configuration
is exported from the first, then imported to the next 7110/7115 in
line. This procedure is repeated for any additional 7110/7115s in
line.