Intel A31032-001 TV Mount User Manual


 
C H A P T E R 3 Intel® NetStructure™ 7110/7115 e-Commerce Accelerator User Guide
3-22
of “default.” Under this initial configuration, automapping occurs on
any server with this network port (443) when traffic is routed through
the 7110/7115.
Automapping with user-specified key and
certificate
When a user-specified key and certificate are to be automapped, the
user can replace the initial automapping entry with the create map
command. By specifying the same unique identifier (server IP of
0.0.0.0, and network port of 443 with a user-generated keyID, the
user can overwrite the initial automapping entry. (The key and
certificate may be obtained through any of the methods described
previously in this chapter.)
Automapping with multiple port combinations
The user can specify multiple automapping entries when the network
port is unique. For example, a user might specify, in addition to the
initial network (443) and server (80) port combination, a combination
of network (8010) and server (80) port.
Deleting automapping entries
Any automapping entry can be deleted, but if the initial automapping
is deleted and no other mapping entry is specified, the 7110/7115
automatically recreates the initial automapping entry. Either replace
the initial automapping entry or create another mapping/automapping
entry and then delete the initial automapping entry using the delete
map command.
Manual mapping
The user can create (with the create map command) one or more
mapping entries for individual servers. This is the only way to specify
unique keyIDs for each server. Normally, when manual mapping is
performed, the initial automapping entry is deleted, but this is not a
requirement.