Filter
Top Products
13
INITIAL SETTINGS
Easy & simple setup
Presetting the built-in TV tuner
automatically—Auto Setup
First time you turn on the power, the unit automatically
shows the Auto Setup screen. Store the TV stations
(programme positions), clock time and Guide Program
numbers using this screen first.
1
Turn on the power.
Press
STANDBY/ON
on the unit or on the remote
control.
• The AUTO SET/T-V LINK screen appear on the TV.
2
Start Auto Setup.
NOTE
If you have connected the unit to a TV offering T-V Link
via a 21-pin SCART cable, the unit starts “TV-linked
Setup” (see page 14) even if you have selected “AUTO
SET.”
NOTES
•Where no TV station transmits Programme Delivery Control
(PDC) signals, the unit cannot set up the clock time and Guide
Program numbers automatically.
•The unit memorizes all detected stations even if their signals
are very weak. You can delete these stations with poor picture
quality later manually (see “To delete a station” on page 71).
•If a power failure occurs, or if you turn off the power while
Auto Setup is in progress, Auto Setup will be interrupted. If this
happens, turn off the power and try again from the beginning.
•Auto Setup may fail or stored information may be incorrect if
received signals are weak.
•If you press any button on the unit or on the remote control
while Auto Setup is in progress, it will be cancelled.
Before starting, make sure of the following:
• The TV aerial cable is connected firmly to the unit.
• The AC power cord is plugged in.
• An appropriate input (AV) mode is selected on the
TV.
When using the remote control, slide the
DVD/TV/
HDD
selector to the right (
HDD
), then
ENTER
.
12
2
1
Press
5
or
∞
to move to
“AUTO SET,” then press
ENTER
or
3
.
• AUTO SET screen appears.
As Auto Setup progresses,
the “ ” mark on the TV
moves from left to right.
(“Au To” starts flashing in
the display window.)
• When Auto Setup is
completed, “SCAN
COMPLETED” appears for
about 5 seconds. The
display window shows the
clock time, “1” (lowest
programme position
number) or “– –:– –” in
sequence as illustrated on
page 15.
Once you have performed Auto Setup correctly, all
the stored TV stations and their Guide Program
numbers will be kept in memory and the unit will not
perform Auto Setup again.
• If a power failure occurs, set the clock manually
(see page 69).
• If you move to a different area, or if a new station
starts broadcasting in your area, perform tuner
setting manually (see page 70).
[SET UP]
[ENTER]
[SET UP]
End
Beginning