Filter
Top Products
9
REMOTE CONTROL SETTINGS
Using the remote control
Installing batteries
Open the compartment cover, and place the two
supplied R6P (SUM-3)/AA(15F) batteries in the remote
control according to the polarity markings (“+” and “–”)
inside the compartment. Then replace the cover.
The batteries will last about 6 months with normal use.
If the remote control functions erratically, replace the
batteries.
Precautions for the safe use of batteries
If the batteries are used improperly, their lives may be
shortened, they may burst or their contents may leak.
Observe the following precautions carefully.
• Remove the batteries from the remote control if it is not
going to be used for a long period of time.
• Never leave used-up batteries lying around,
disassemble them, mix them with other refuse, or
throw them into an incinerator.
• Never touch liquid if it has leaked out of a battery.
• Do not mix new and old batteries, or batteries of
different types, when replacing them.
• Remove used-up batteries and dispose of them
properly.
When the discarding batteries, environmental
problems must be considered and the local rules or
laws governing the disposal of the used-up batteries
must be followed strictly.
Remote sensor
Point the top of the remote control toward the remote
sensor as directly as possible. If you operate it from a
diagonal position, the operating range (approx. 5 m) may
become shorter.
Controlling the TV using remote
control
Your remote control can operate the basic functions of
your TV. In addition to JVC products, other
manufacturer’s equipment can also be controlled.
To set the TV’s brand code.
1. Slide the DVD/TV/HDD selector to the centre position
(TV).
2. Press and hold TV AV until the setting is over.
3. Press number buttons to enter the brand code, then
press ENTER.
• See the brand code table on page 10.
4. Release TV AV.
5. To confirm whether the setting is correctly done or not,
press repeatedly.
• If the equipment turns on and off, the setting is
done correctly.
• If the equipment does not turn on and off with one
code, try entering another.
NOTES
•Once you have set the remote control to operate your
equipment, you do not have to repeat this step until you
replace the batteries from the remote control.
•You can also change the remote control code for operating JVC
video products. See page 82 for details.
1
2
4
3
3