Filter
Top Products
84
EXTERNAL COMPONENT OPERATIONS (cont.)
Editing to or from a VCR
You can use the HDD deck as the playback component
or as the recording deck.
To use the HDD deck for the playback component:
1
Make connections
Connect the VCR through the L-1 IN/OUT connector on
the rear using the 21-pin SCART cable (not supplied).
•
If the external VCR is compatible with S-Video signal:
Set “L-1 OUTPUT” to “S-VIDE
O” (see page 68).
2
Select the HDD deck.
On the remote control
Set the
DVD/TV/HDD
selector set to the right (
HDD
),
then press
ENTER
(or
LIVE
).
On the unit
Press
DVD/HDD
so that the HDD lamp lights.
3
Select the input mode on the VCR.
• Refer to the instruction manual supplied with the VCR.
4
Start playback on the HDD deck.
Press
3
(
SELECT
).
• You can also use HDD Navigation (see page 29).
5
Start recording on the recording component.
• Refer to the instruction manual supplied with the VCR.
NOTES
•For Y/C signal input/output, be sure to use a 21-pin SCART
cable that is compatible with the Y/C signal.
•When you use the HDD deck as the playback component, be
sure to set “O.S.D.” to “OFF” before starting (see page 67).
•If the VCR is equipped with audio/video (VIDEO/S-VIDEO)
input connectors, you can also connect it using those
connectors.
ANTENNA
L-1
VIDEO SIGNAL
SELECTOR
VIDEO
OUT
AUDIO
OUT
L-2
OUT
IN
/
OUT
DVDDVD
/
HDD
SAT CONTROL
AV
COMPU LINK
IN
OPTICALCOAXIAL
DVD DIGITAL OUT
PCM / STREAM
LEFT
RIGHT
IN
Y
/
C
COMP.
/
RGB
S-VIDEO
VIDEO
ANTENNA
L-1
VIDEO SIGNAL
SELECTOR
VIDEO
OUT
AUDIO
OUT
L-2
OUT
IN
/
OUT
DVDDVD
/
HDD
SAT CONTROL
AV
COMPU LINK
IN
OPTICALCOAXIAL
DVD DIGITAL OUT
PCM / STREAM
LEFT
RIGHT
IN
Y
/
C
COMP.
/
RGB
S-VIDEO
VIDEO
Connection only with the SCART cables
When the VCR is not compatible with S-Video signal,
but the TV is compatible:
XV-DDV1SL
21-pin SCART
cables (not supplied)
VCR
TV
VCR
S-video cable
(not supplied)
21-pin SCART
cables (not supplied)
XV-DDV1SL
TV