Filter
Top Products
14
INITIAL SETTINGS (cont.)
Downloading the preset information
from your TV—TV-linked Setup
If you have connected the unit to a TV offering T-V Link,
etc.* (see page 11), perform TV-linked Setup instead of
Auto Setup.
• After downloading TV station information from the TV,
the unit sets the clock time and Guide Program
numbers automatically.
NOTE
* T-V Link, EasyLink, Megalogic, SMARTLINK, Q-Link or DATA
LOGIC.
1
Turn on the power.
Press
STANDBY/ON
on the unit or on the remote
control.
• The AUTO SET/T
-
V LINK screen appears on the TV.
2
Start TV-linked Setup.
NOTES
•Where no TV station transmits Programme Delivery Control
(PDC) signals, the unit cannot set up the clock time and Guide
Program numbers automatically.
•If a power failure occurs, or if you turn off the power while TV-
Linked Setup is in progress, TV-Linked Setup will be
interrupted. If this happens, turn off the power and try again
from the beginning.
•Clock time setting may fail if received signals are weak.
•The characters available for station names (ID) are A–Z, 0–9,
–,
*
, + and (space). Downloaded station names may differ from
the ones listed on pages 73 and 74.
•If you press any button on the unit or on the remote control
while TV-linked Setup is in progress, it will be cancelled.
12
2
1
Press
5
or
∞
to move to
“T-V LINK,” then press
ENTER or
3
.
• T-V LINK screen appears
for a while, then GUIDE
PROG SET screen appears
while setting Guide
Program numbers.
• When TV-linked Setup is
completed,
“COMPLETED” appears
for about 5 seconds. The
display window shows the
clock time, “1” (lowest
programme position
number) or “– –:– –” in
sequence as illustrated on
page 15.
[ENTER]
[SET UP]