Filter
Top Products
Chapter 6 The Menu System
Chapter 6 The Menu System
115
Changing the Signal Type
The Signal Type menu lets you choose whether you are receiving a signal from
cable TV or an off-air antenna. When you run Channel Search, the TV automatically
detects your signal and you don’t have to specify it here. However, if you decide to
change the source, you will need to use the Signal Type menu.
Note: When your LCOS HDTV is in DIRECTV mode, this menu isn’t available.
Reminder:
Make sure the Ch 2/3/4 switch on the back of the
component is set to the channel you specify in the Auto
Tuning screen.
Select whether you are receiving signals
from an off-air antenna or cable.
Auto Tuning
This menu displays the various components you have connected to your TV. It lets
you program a component button on the remote control (VCR1, VCR2, or DVD) so
that pressing the button automatically turns on the component, turns on the TV, and
tunes the TV to the correct video input channel.
1. Press the arrow buttons on the remote control to highlight the rectangular field
that corresponds to the component.
2. Press the OK button on the remote to choose the input channel the TV needs
to tune to when you press that component button. Choices for each
component are:
Not Connected Select this if you don’t have the component connected to the
antenna or video input jacks on the back of the TV, or if you don’t want the TV
to tune to a channel when the particular component button (VCR1, VCR2, or
DVD) is pressed.
Ch 2 (or 3 or 4) - Ant A Select this if your component is connected to
Antenna A on the back of the TV and you want the TV to tune to channel 2 (or
3 or 4) when you press the component button (VCR1, VCR2, or DVD).
Ch 2 (or 3 or 4) - Ant B Select this if your component uses Antenna B on
the back of the TV and you want the TV to tune to channel 2 (or 3 or 4) when
you press the component button (VCR1, VCR2, or DVD).