Filter
Top Products
Chapter 3 The Remote Control
Chapter 3 The Remote Control
57
5. Once you have selected the FROM MODE component, the display message prompts you to enter the TO
MODE component. Push the desired component button.
6. When a valid TO MODE component is entered, the remote automatically processes the mode reassignment
and SUCCESS appears. The remote will then EXIT SETUP and return to normal operation.
NOTES:
• Press the CLEAR button at any time to exit the programming mode (EXIT SETUP appears and the
remote return to normal operation).
• If any button other than a valid component button is entered, INVALID appears and the remote will
remain in this FROM MODE or TO MODE programming mode until a valid component is entered.
• If about 30 seconds passes before a button is pressed, the remote’s display window will stop
transmission to conserve battery life. If this occurs, restart from step 1.
How to Set the Clock
1. Press and hold (the backlight button) until CODE SET appears in the remote’s display.
2. Step through the programming menu by pressing the down arrow button until CLOCK SET appears in the
remote’s display, then press the OK button.
3. After you press the OK button, the remote will display the hours and minutes.
4. Use the up arrow button to modify the hours and the down arrow button to modify the minutes.
NOTE: To set the AM or PM appropriately use the up arrow button and step through the hours for the
correct setting.
5. Once the time is set correctly, press the OK button to complete the setup (SUCCESS followed by EXIT
SETUP appears).
DIRECTV
VCR
1
VCR
2
ON•OFF
TV
DVD
AUX
AUD
M1
L1
M2
L2
M3
L3
FRONT
SKIPMUTE
CH +
VOL +VOL -
CH -
CENTERREAR
GO
BACK
FORMAT
TEST
GUIDE INFO
AM•FM