Filter
Top Products
Chapter 3 The Remote Control
Chapter 3 The Remote Control
51
Note: Too much light (either natural or fluorescent) might cause the learning
feature to fail since the remote controls are passing data via infrared (IR)
signals.
7. Repeat steps 5 and 6 to store more functions.
8. When the selected functions are stored press the CLEAR button to exit (EXIT
SETUP appears in the remote’s display and the remote returns to original
operation mode).
Notes:
• Every time a code is successfully learned, SUCCESS appears in the display.
• Press the CLEAR button at any time to exit the programming mode (EXIT
SETUP will appear to confirm that no new codes have been entered).
• If you press a button that can’t be used to learn another function,
INVALID appears in the remote’s display.
• The learning capacity is approximately 16 to 25 buttons, depending on
the function being learned.
How to Delete a Learning Sequence (L1, L2, and L3
buttons) — IR DELETE
To delete a learned button sequence, either overwrite it with a new button, or use
the procedure below.
1. Press and hold
(the backlight button) until CODE SET appears in the
remote’s display.
2. Step through the programming menu by pressing the down arrow button until
IR DELETE appears in the remote’s display, then press the OK button.
3. Press the button to be deleted (L1, L2, L3) on your remote control.
4. If the button is a valid one, the learned data that was stored in the button has
now been deleted (DELETED appears in the remote’s display).
continues on next page
continues on next page
DIRECTV
VCR
1
VCR
2
ON•OFF
TV
DVD
AUX
AUD
M1
L1
M2
L2
M3
L3
FRONT
SKIPMUTE
CH +
VOL +VOL -
CH -
CENTERREAR
GO
BACK
FORMAT
TEST
GUIDE INFO
AM•FM
OK LEVEL +LEVEL -
MENU
PROGRAM
CLEAR
123
456
789
0
INPUT ANT
FUNCTION
STOP PAUSEREC
PLAY FWDREV
SWAP
CH
CTRL
PIP WHO
DSP
ON•OFF
DSP
MODE
DELAY
Display
window
The down
arrow button
The OK
button
The backlight
button
L1, L2, L3
buttons