Filter
Top Products
Chapter 3 The Remote Control
Chapter 3 The Remote Control
46
8. Press OK to save the code (SUCCESS appears in the remote’s display window followed by EXIT SETUP ).
Note: The code list defaults so you can only scroll through the list once. When the remote is finished
advancing through all of the codes in its library, END CYCLE appears flashes in the display, followed by EXIT
SETUP.
9. Make sure the remote has correctly programmed the desired component (in this example, your VCR): press
the VCR1 button followed by the ON•OFF button to see if your VCR turns on. If the component doesn’t
turn on, try the following:
• Try again by repeating the previous steps.
• Try programming the remote using direct entry method (go to page 48).
• Use the Learning Feature to transfer the component’s most important functions to your LCOS TV remote
control (go to page 50).
• Review the following notes.
Notes:
• This remote control cannot be programmed to operate some brands of components.
• If approximately 30 seconds passes before a button is pressed, the display window stops transmission to
conserve battery life. If this occurs, restart from step 1.
• To exit programming mode, press the CLEAR button at any time (EXIT SETUP appears in the remote’s
display to confirm that no new codes have been entered).