Filter
Top Products
Chapter 2 Connections & Setup
Chapter 2 Connections & Setup
23
Put Batteries in the Remote Control
Follow these steps whenever you need to install or change the batteries in your
TV’s remote control.
1. Remove the cover from the battery compartment.
2. Insert batteries into the battery compartment, matching the + and – end of
each battery (look for the diagram inside of the battery compartment).
3. Replace the cover.
Plug in and turn on
Plug one end of the power cord into the back of the television. Plug the other end
into a wall outlet. Be sure to insert the plugs completely.
Note: Plug your television directly into a wall outlet or power strip (or surge
protector) — don’t plug the TV into a wall outlet that is controlled by a light
switch.
To turn on the TV, press the ON•OFF button. Your LCOS television has to check
many functions the first time you turn it on (somewhat like a computer booting
up). You’ll notice that it takes a minute or so for the TV to completely warm up.
Be patient — it’s worth the wait!
Complete the Interactive Setup
The Interactive setup appears when you turn on your TV for the first time. Press
the arrow buttons (up, down, left, and right) on your remote control to highlight a
menu item. Press OK to select the highlighted item.
Follow the steps to configure the basics of your system, such as setting up the
time and day, searching for available channels, and setting up speakers. If you
ever need to run the Interactive Setup again or make adjustments, go to the
Assistance menu that’s found in the main menu (for more details, go to page 137
in Chapter 7).
POWER
Step 3
Step 4
Step 5
GO
BACK
FORMAT
TEST
GUIDE INFO
AM•FM
OK LEVEL +LEVEL -
MENU
PROGRAM
CLEAR
123
Arrow buttons
and the OK
button