Filter
Top Products
Main code Sub code Content
26 20 Rear edge void setting
Used to set YES/NO of the paper rear edge void.
When this simulation is executed, the currently set rear edge void mode is displayed on the copy quantity display.
Enter the set value and press the PRINT button to store it.
Set value Rear edge void
0 Yes ← Initial value
1No
26 Auto shut off mode cancel
In Japan/SEC, the auto shut off function cannot be canceled by the user. In can be canceled by a serviceman.
(This simulation is available for all the destinations.)
Enter the set value and press the PRINT button to store it.
Set value Set content
0 Auto shut off cancel inhibited ← Initial value
1 Auto shut off cancel allowed
When this simulation is set to “1,” the value of “P3” in the user simulation becomes “0” and the mode change
cannot be made in the user simulation.
When this simulation is set to “0,” the value of “P3” in the user simulation is set as the initial value.
30 01 Paper sensor state display
Used to monitor the ON/OFF state of the sensors in the main body with the LED on the operation panel.
Sensor name Operation panel LED
PID Manual feed tray selection lamp
PPD Drum position jam lamp (▼)
PPD1 Resist position jam lamp (▼)
PPD2 Main body lower step tray position jam lamp (▼)
PPD3 Paper empty lamp (ç)
PPD4 Jam lamp (ê)
POD Paper exit position jam lamp (▼)
POD2 ADU position jam lamp (▼) ← SF-2120 only
PED1 Body upper step tray selection lamp (▼) ← SF-2020 only
PED2 Body lower step tray selection lamp
PED3 PFU upper step tray selection lamp
PED4 PFU lower step tray selection lamp
02 Tray size switch state display
Used to monitor the ON/OFF state of the tray size switch with the LED on the operation panel.
Selection of trays is made by the tray selection key.
Switch name Operation panel LED
SW2 Paper exit position jam lamp (▼) Switches are arranged
in the sequence of
SW2, SW1, and SW0
from the paper exit side.
SW1 Drum position jam lamp (▼)
SW0 Resist position jam lamp (▼)
Tray position Each tray selection LED
8 – 11