Filter
Top Products
Main code Sub code Content
02 10 ADF individual load operation check (paper feed motor + paper feed solenoid)
11 ADF individual load operation check (transport motor forward rotation + repulsion motor forward rotation) A57 only
03 02 Sorer sensor state display
The ADF sensor ON/OFF states can be monitored with the LED on the operation panel.
When the third digit of the multi display is “A,” the following display is made.
Sensor name Operation panel LED
Entrance sensor Jam lamp (ê)
Tray paper presence/empty sensor Paper empty sensor (ç)
Upper limit sensor Manual feed selection lamp
Lower limit sensor Resist position jam lamp (▼)
Bin home position sensor Drum position jam lamp (▼)
Take-out sensor Paper exit jam lamp (▼)
Alignment bar home sensor ADF section jam lamp (▼) S54 only
If, at that time, the magnification ratio display key is pressed, the third digit of the multi display is changed to “B”
and the following display is made.
Sensor name Operation panel LED
Pinch (hold) home sensor Jam lamp (ê) S54 only
Stapler home sensor Paper exit position jam lamp (▼) S54 only
Stapler paper sensor Paper empty jam lamp (ç) S54 only
Stapler near end sensor Resist position jam lamp (▼) S54 only
03 Sorter individual load operation check (Transport motor)
04 Sorter individual load operation check (Bin motor)
05 Sorter individual load operation check (Buzzer)
06 Sorter individual load operation check (Alignment motor)
07 Sorter individual load operation check (Pinch hold motor)
05 01 Operation panel display check
All the LED’s on the operation panel are lighted for 5 sec.
When the automatic original feed unit is installed, the original feed lamp and the original remaining lamp are also
lighted for 5 sec.
02 Heater lamp lighting check
The heater lamp is turned of/off in the following sequence.
03 Copy lamp lighting check
The copy lamp is turned on/off in the following sequence.
0.5s 0.5s 0.5s
PR
HL
0.5s
1s
PR
CL
5s
Full power ON Data ON (Can be set by the exposure key arbitrarily
8 – 5