Filter
Top Products
5. Memory simulation list
Purpose/kind Section
Contents
Ref. page
Main
code
Sub
code
Default
value
Description
Adjustment
Paper feed
section
51 02 50 Adjustment value of contact pressure of the paper on the main
body resist roller
8-19
Optical unit
50 01 Copy paper lead edge void amount adjustment
(Resist adjustment A)
8-18
Copy paper lead edge void amount adjustment
(Resist adjustment B)
Copy paper lead edge void amount adjustment
(Lead edge void adjustment )
Copy paper lead edge void amount adjustment
(Rear edge void adjustment)
46 01 Adjustment value of copy density (exposure level) in each copy
mode and of copy density gradient (exposure gradient)
8-17
Manual copy mode density level 1 (Not toner save mode)
Manual copy mode density level 5 (Not toner save mode)
Manual copy mode density level 1 (Toner save mode)
Manual copy mode density level 5 (Toner save mode)
Auto copy mode density level 1 (Not toner save mode)
Auto copy mode density level 5 (Not toner save mode)
Auto copy mode density level 1 (Toner save mode)
Auto copy mode density level 5 (Toner save mode)
Photo copy mode density level 1 (Not toner save mode)
Photo copy mode density level 5 (Not toner save mode)
47 The AE sensor and the optical section characteristics memory data
for the change in the copy lamp application voltage
8-17
48 01 50 The vertical copy magnification ratio adjustment value 8-17
02 50 The horizontal copy magnification ratio adjustment value (when the
document table is used)
8-18
Developer unit 25 02 Toner density initial set value 8-9
Setting Specifications 26 06 Specifications setting by destination 8-10
Fuser unit 26 13 0 Setting of the main motor operation mode in warming up. 8-10
43 01 185°C Fusing temperature set value 8-13
Maintenance
counter
21 01 Maintenance cycle setting 8-8
02 Mini maintenance cycle setting 8-8
Developer unit 22 06 Used to confirm the developer counter value of the installed
developer unit.
8-8
07 Used to confirm the developer replacement cycle of the installed
developer unit.
8-8
Code No. Destination
0 Japan
1 U.S.A.
2 Canada
3 Europe except U.K.
4 U.K.
5 Australia
6 Inch series outside Japan
7 AB series outside Japan
Code
No.
Operation
mode
Operation
0
Normal
mode
When the fusing temperature reaches
the specified level, the main motor stops.
1
Long
mode
The main motor keeps rotating until the
completion of the warming up.
10 – 4