Filter
Top Products
5-2. Transfer/separation charger (TC/SC) unit
1 Open the font cover, open the body up.
2 Push TC/SC unit pawl sections A (2 positions) and lift the front
side and pull it out.
(Cleaning/replacement and precautions)
1 Set the charger SP length to 17 ±1.0mm.
2 The charger wire must be free from distortion and deformation,
and must be in the wire positioning groove of each holder.
3 The charger case must be free from oil, dirt or adhesion of foreign
material.
4 Clean the wire with alcohol.
5 When installing the unit to the body, check that the grounding
spring is in contact with the TC/SC case (metal section) on the
rear and the front sides. (Visually check, and push the center of
the TC/SC unit to check that it can be moved up and down.)
6 Transfer mylar lower
6. Process section
6-1. Process unit
1 Open the front cover, remove the developing unit, and open the
clamshell.
2 Remove process cover A. (Loosen the screw to remove.)
3 Loosen two blue screws which are fixing the unit. Remove one
screw, disconnect one connector, and remove unit B. (Do not
hold the toner transport pipe.)
A
17 1.0
3~5mm
Front
TCUN
Rear
Front pawl
Base plate
Rear pawl
0~0.5
1.5 0.5
1.0 0.5
TC mylar lower
attachment reference
A
B
6 – 17