Filter
Top Products
Getting Started Teledyne API T703/T703U Calibrator Operation Manual
42
3.4.4. FUNCTIONAL CHECK
1. After the calibrator’s components have warmed up for at least 30 minutes, verify
that the software properly supports any hardware options that are installed.
2. Check to make sure that the calibrator is functioning within allowable operating
parameters. Appendix C includes a list of test functions viewable from the
calibrator’s front panel as well as their expected values. These functions are also
useful tools for diagnosing problems with your calibrator (see Section 8.1.2). The
encl
o
sed Final Test and Validation Data sheet (part number 05760) lists these
values before the instrument left the factory.
To view the current values of these parameters press the following touch screen button
sequence on the calibrator’s front panel. Remember until the unit has completed its
warm up these parameters may not have stabilized.
If your calibrator is operating via Ethernet and your network is running a dynamic host
configuration protocol (DHCP) software package, the Ethernet option will automatically
configure its interface with your LAN. However, it is a good idea to check these
settings to make sure that the DHCP has successfully downloaded the appropriate
network settings from your network server (See Section 5.6.1).
If yo
ur network is not running DHCP, you will have to configure the calibrator’s
interface manually (See Section 5.6.1.1).
07223C DCN6572