A&D PD4000243 Universal Remote User Manual


 
Page 106 AD-4402
10.4.
10.4.10.4.
10.4. Parameter List
Parameter ListParameter List
Parameter List
Category address
:
[Function] - [Function setting] - [General] - [Weighing]
Category
address
symbol
Name Descriptions
Range
and
choices
Default
genf- 1
Display refresh rate
1: five times per second
2: ten times per second
1 to 2 2
genf- 2
Digital filter
0: Not used
1: 11 Hz
2: 8.0 Hz
3: 5.6 Hz
4: 4.0 Hz
5: 2.8 Hz
6: 2.0 Hz
7: 1.4 Hz
8: 1.0 Hz
9: 0.7 Hz
Select 3dB band for two
low pass filters.
0 to 99
4 8
genf- 3
Sampling
freqeuncy divider
Use to decrease the cut-off frequency of
digital filter.
0 to 10 1
genf- 4
Stability detection
time
0.0 to
9.9 s
1.0 s
genf- 5
Stability detection
band width
The detection condition concerning
satblility.
0.0 : stable at anytime.
0.0 to
9.9 d
2.0 d
genf- 6
Zero Range
The range to zero gross display.
Center of range is zero calibration.
Unit: percentage of weighing capacity.
0 to 30 % 5 %
genf- 7
Zero tracking time
0.0 to
9.9 s
0.0 s
genf- 8
Zero tracking band
width
The function automatically traces the
weighing deviation at nearly zero
point and keeps zero display of gross
display.
0.0 to
9.9 d
0.0 d
genf- 9
Tare and zero
compensation at
unstable status
When unstable weghinng, whether zero
or tare command is used.
0 :Disabled
1 :Enabled
0 to 1 1
genf-10
Tare at negative
GROSS weight
When negative weghinng, whether tare
command is used.
0 :Prohibition to tare.
1 :Permission to tare.
0 to 1 1
genf-11
Preset tare
Preset tare of material code
0 :Not used
1 :Use
0 to 1 1
genf-12
Preset tare =0
choice
1: If tare value of material code is zero,
the last tare value is used.
2: If tare value of material code is zero,
Tare is set to zero.
1 to 2 1
First filter
Second filter
A/D converter