Filter
Top Products
AD-4402 Page 27
6.1.5.
6.1.5.6.1.5.
6.1.5. Editing Full Parameters of Material Code
Editing Full Parameters of Material CodeEditing Full Parameters of Material Code
Editing Full Parameters of Material Code
A material code consists of the following parameters.
Name
Display Name Display
Symbol
Display
Example
Memory
Material Code
Code
Code
11
Material name
Mat Name grain
Material Hopper No.
Mat Hopper Hopper 1
Final
Final Final 10.00 kg
Free Fall
Free Fall FFall 0.01 kg
Preliminary
Preliminary Plm 1.00 kg
Optional Preliminary
OP.Preliminary OPPlm 2.00 kg
Over
Over Over 0.10 kg
Under
Undr Undr 0.10 kg
Zero Band
Zero Band 0Band 0.02 kg
Full
Full Full 0.05 kg
Tare
Tare Tare 5.00 kg
Supplementary Flow Open Timer
SF open timer SFOT 0.00 s
Supplementary Flow Close Timer
SF close SFCT 0.00 s
Automatic Free Fall Range
AFFC range AFFC 0.00 kg
Initial Dribble Flow
Initial DF IDF 0.00 kg
Initial Medium Flow
Initial MF IMF 0.00 kg
Backed up
RAM
( factory
setting)
or
flash
memory
Total Weight
Tot Tot 10.00 kg
Total Counts
Tot# Tot# 1
Backed up
RAM
These parameters are stored in backup memory without power supply.
Refer to the backup method [0tHf-11] of the function list.
Caution
If the flash memory is selected for memory backup [0tHf-11
0tHf-110tHf-11
0tHf-11], a current
sequential weighing is stopped.
Edit Material Code
Step 1 Press and hold the ENTER key and press the key.
Then menu MatEdit blinks.
Step 2 Press the ENTER key to enter the material code edit. Then menu Edit blinks.
Step 3 Press the ENTER key to enter menu edit.
Step 4 Select the material code using numerical keys and press the ENTER.
Step 5 Enter the material name using alpanumerical keys and press the ENTER key.
Step 5 Edit other parameters using numerical keys, ENTER key and key.
Step 6 If you want to finish the change, press the ESC key to return to weighing mode
several times.