Filter
Top Products
AD-4402 Page 43
7.3.3.
7.3.3.7.3.3.
7.3.3. C
CC
Compensation
ompensation ompensation
ompensation S
SS
Sequence
equenceequence
equence
The compensation sequence is used to make up (add) the material automatically,
when the result of current batch weighing is under weight.
Concerning Parameters of the Function
Storing a maximum repeat counts of compensation sequence.
[5q f-18] If number is zero, this sequence is canceled. When the result is
under weight after the sequence, An error SQ.ERR 2 is displayed.
[Function] - [Function setting] - [Sequence] - [Control] - [Maximum number
of compensation]
Setting the time to open the dribble gate.
Set the time at each material code.
[Function] - [Function setting] - [MatEDIT] - [Edit] - [Compensation flow open
timer]
Setting the time to close the dribble gate.
Set the time at each material code.
When the weighing value is stable and under weight, the
compensation is repeated. Take a longer time closing gate, if it does
not use a stable signal.
[Function] - [Function setting] - [Material Edit] - [Edit.] - [Compensation flow
close timer]
Removing the nozzle at this sequence, when the nozzle operation is used.
[5q f-12] [2] Nozzle contact stop sequence
Factory setting is "not used". When it is necessary to shift up the
nozzle to reduce a weighing error, use this parameter of [5q f-12].
[Function] - [Function setting] - [Sequence] - [Control] - [Nozzle control]