Filter
Top Products
AD-4402 Page 63
Advise
Using the automatic switch of normal batch and loss-in weight.
Specify the output terminal for the hopper number in the material code on the I/O.
Specify the input terminal to change the mode on the I/O. [1n f-nn] [9]
Connect the output terminal to the input terminal.
Connect the output common terminal to the input common terminal.
Set the delay time above 0.1 second at [5qf-32] Batch start delay timer.
0
Weighing value
Dribble flow, Output
Batch finish, Output
Over weight, Output
Under weight, Output
Medium flow, Output
Full flow, Output
Material code, Input
Eval delay timer
Stable, Output
Acceptable, Output
Net weight
Gross weight
5qf-37
Free fall
Preliminary
Optional preliminary
Zero band
Tare command, Input
Final value
Full filling
Comparison
Start command, Input
Waiting time
r
and stable.
Set the condition
at 5qf-13
If this command is
used, accumulation
and comparison can
be used.
Full filling value
- Final value + Optional preliminary
- Final value + Preliminary
- Final value + Free fall
- Final value
or -Target weight
The active code is
only read at each
start. And keep it.
Dribble flow comparison interrupt timer
Medium flow comparison interrupt time
r
Full flow comparison interrupt timer
5qf
-
33
5qf-35
5qf-34
5qf-43
Batch finish output
o
n
Select a mode
at 5qf-05