Filter
Top Products
AD-4402 Page 73
The function assigned to terminals
The function of the terminal can assign arbitrarily. Refer to 10.4. Parameter list of the
Function list
8.1.2.
8.1.2.8.1.2.
8.1.2. Timing Chart
Timing ChartTiming Chart
Timing Chart
Caution
Keep the delay time to avoid mis-operation and noise.
Set the Communication mode in [01 f- 3] [without 5].
The transmission of BCD data synchronizes with displaying it in the following modes.
Stream mode, auto print mode, manual print mode and accumulation print.
Exmaple
Strobe signal
Data output
Hold input command
Max. 50 ms delay
time until holding data
Max. 50 ms delay time to
release the hold command.
A
pprox. 10 ms from new
data edge to strobe signal.
10
ms
/di
v
A
pprox. 20 ms width