Filter
Top Products
Page 26 AD-4402
6.1.3.
6.1.3.6.1.3.
6.1.3. Editing Principle Parameters of Material Code
Editing Principle Parameters of Material CodeEditing Principle Parameters of Material Code
Editing Principle Parameters of Material Code
You can edit the parameters of target weight, free fall and etc. displayed on the sub-
display during a weighing. And items of sub-display can be selected at the menu
[Function] - [Function setting] - [General] - [Sub-display].
Caution
If the flash memory is selected for memory backup (0tHf-11
0tHf-110tHf-11
0tHf-11), a current
sequential weighing is stopped.
Step 1 Press and hold the SHIFT key and press the CODE RECALL key.
Then the material code blinks.
Step 2 Enter the material code using numerical keys
The details of the material code are displayed in the sub-display.
Step 3 Press the ENTER key to decide the code.
Step 4 Select a parameter using the key on the sub-display.
Step 5 Enter the parameter using numerical keys and press the ENTER key to store it.
Step 6 If you continue the change, proceed step 4 and 5.
Step 7 If you want to finish the change, press the ESC key to return to weighing mode
several times.
6.1.4.
6.1.4.6.1.4.
6.1.4. Referr
ReferrReferr
Referring
inging
ing next Material Code
next Material Code next Material Code
next Material Code
You can refer to next material code in the sequential mode that uses plural material
codes. Suppose that the recipe code is not used. (The menu
[Function] - [Function
setting] - [Sequence] - [Basic] - [Recipe mode]
is set to [5q f- 8] [0])
Step 1 Press the CODE RECALL key.
Then principle parameters of the next material code are displayed in the sub-
display.
Step 2 Press the ESC key to return to current mode.